Related Experiment Video
Updated: Jun 17, 2025

An Inertial Measurement Unit Based Method to Estimate Hip and Knee Joint Kinematics in Team Sport Athletes on the Field
Published on: May 26, 2020
Quantifying internal and external training loads in collegiate male volleyball players during a competitive season
Han-Szu Lin1, Huey-June Wu1, Chung-Cheng Wu2
1Graduate Institute of Sport Coaching Science, Chinese Culture University, Taipei, Taiwan.
Background:
The long-term monitoring of internal and external training load is crucial for the training effectiveness of athletes. This study aims to quantify the internal and external training loads of collegiate male volleyball players during the competitive season. The internal and external training load variables were analyzed across mesocycles and playing positions.
Methods:
Fourteen participants with age of 20.2 ± 1.3 years, height of 1.81 ± 0.05 m, and body weight of 70.8 ± 5.9 kg were recruited. The data were collected over a 29-week period that was divided into four mesocycles: preparation 1 (P1, weeks 1-7), competition 1 (C1, weeks 8-14, including a 5-day tournament in week 14), preparation 2 (P2, weeks 15-23), and competition 2 (C2, weeks 24-29, including a 6-day tournament in week 29). Each participant wore an inertial measurement unit and reported the rating of perceived exertion in each training session. The internal training load variables included weekly session rating of perceived exertion, acute: chronic workload ratio, and training monotony and strain. The external training load variables included jump count and height and the percentage of jumps exceeding 80% of maximal height.
Results:
C2 had the highest average weekly internal training load (3022 ± 849 AU), whereas P2 had the highest average weekly acute: chronic workload ratio (1.46 ± 0.13 AU). The number of weekly jumps in C1 (466.0 ± 176.8) was significantly higher than in other mesocycles. Weekly jump height was significantly higher in C1, P2, and C2. Internal training load was positively correlated with jump count (ρ = 0.477, p < 0.001). Jump count was negatively correlated with jump height (ρ = -0.089, p = 0.006) and the percentage of jumps exceeding 80% of maximal height (ρ = -0.388, p < 0.001). The internal and external training load variables were similar among different playing positions.
Conclusion:
The participants exhibited significantly higher internal training load in C2 and higher jump height after P1. A high jump count was associated with higher internal training load and lower jump height. Excessive jumps may result in fatigue and reduce height.
Related Concept Videos
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Internal Loadings in Structural Members: Problem Solving
To illustrate this, let's consider a beam OC of 5 kN, inclined at an angle of 53.13° with the horizontal and supported at both ends. Determine the internal...
Impact Loading
In cases of elastic deformation,...
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
Normal Strain under Axial Loading
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes....

