Correlation between kinematic parameters, ataxia and ground-to-lip distance in detomidine sedated horses

Jorge Izquierdo-Moreno1, Marta Illán de Paz1, Gabriel Manso-Díaz1

  • 1Department of Animal Medicine and Surgery, Veterinary Faculty, Complutense University of Madrid, Madrid, Spain.

PubMed
Abstract

Related Concept Videos

Velocity and Position by Graphical Method01:34

Velocity and Position by Graphical Method

Velocity and position can be calculated from the known function of acceleration as a function of time. The total area under the acceleration-time graph and the velocity-time graph gives the change in velocity and position, respectively. In the case of an airplane, its acceleration is tracked using the inertial navigation system. The pilot provides the input of the airplane's initial position and velocity before takeoff. The inertial navigation system then uses the acceleration data to calculate...
Velocity and Position by Integral Method01:13

Velocity and Position by Integral Method

If acceleration as a function of time is known, then velocity and position functions can be derived using integral calculus. For constant acceleration, the integral equations refer to the first and second kinematic equations for velocity and position functions, respectively.
Consider an example to calculate the velocity and position from the acceleration function. A motorboat is traveling at a constant velocity of 5.0 m/s when it starts to decelerate to arrive at the dock. Its acceleration is...
Work and Energy for Variable Forces01:10

Work and Energy for Variable Forces

When an object is acted upon by a variable force, the amount of work done and the change in energy of the object can be more complex to calculate compared to when a constant force is applied. Work is the product of force and displacement, while energy is the capacity of a system to do work. When a constant force is applied to an object, the work done can be calculated as the product of the force and the distance moved in the direction of the force. However, when a variable force is applied, the...
Relative Motion Analysis - Velocity01:24

Relative Motion Analysis - Velocity

A stroke engine has a slider-crank mechanism that converts rotational motion from the crank into linear motion of the slider or vice versa. This mechanism consists of three main parts: the crank, the connecting rod, and the slider.
When an external force is exerted, it sets the crank into a rotational movement. This, in turn, instigates the motion of the connecting rod, leading to what is referred to as a general plane motion. This process involves two key points - point A on the connecting rod...
Velocity Potential01:20

Velocity Potential

In steady, incompressible flow through a long, straight pipe with a uniform cross-section, the flow in the central region (far from the pipe walls) is irrotational. This irrotational nature means that fluid particles do not rotate around their axes, and a scalar function called the velocity potential, represented by ϕ, can be used to describe their movement. In irrotational flows, the velocity field V is defined as the gradient of the velocity potential:
Distance Problem01:29

Distance Problem

When an object's velocity changes over time, the total distance traveled can be determined by summing small displacement intervals over short increments. This approach approximates the true distance through numerical summation and the use of integral calculus. An estimate of the total displacement can be obtained by measuring velocity at regular intervals and multiplying each value by the corresponding time step.If a runner accelerates over the first three seconds of a race, speed measurements...