Direct measurement of self-diffusiophoretic force generated by active colloids of different patch coverage using...

Synthetic micro/nanomotors are gaining extensive attention for various biomedical applications (especially in drug delivery) due to their ability to mimic the motion of biological micro/nanoscale swimmers. The feasibility of these applications relies on tight control of propulsion speed, direction, and type of motion (translation, circular, etc.) along with the exerted self-propulsive force. We propose to exploit the variation of both self-propulsion speed and force of active colloids with different patch coverages (with and without supporting layer) for engineering diffusiophoretic micro/nanomotors.

The microswimmers were designed at various patch coverages (10°, 30°, and 90°) with (Ti/Pt) and without (Pt) an adhesion layer for the catalytic patch through glancing angle metal deposition (GLAD) technique. Mean-square displacement (MSD) analysis was performed to obtain the self-propulsion parameters like speed and angular speed. Using optical tweezers (OT), the self-propulsive force was measured from the force power spectral density.

The findings of our experiments suggest the non-requirement of any adhesion layer preceding the catalyst deposition since the Pt 10° colloidal batch had the maximal self-propulsion speed (4.61±0.3μm/s) and force (345±57fN) for 5% w/v H₂O₂ fuel concentration. Moreover, the self-propulsion speed and force decreased with increasing patch size, contrary to theoretical estimates. Also, the self-propulsive force obtained from MSD is 2 to 4 times lower in magnitude than the OT based force values. We believe that the self-propelling motion of the micromotors is possibly hindered due to interactions with the surface of the quartz cuvette during the optical microscopic analysis. Further, the MSD is limited to the self-propulsive motion in two dimensions. On the other hand, OT based force measurement involve trapping the particles in the bulk of the solution entirely avoiding the particle-substrate interactions. Hence, OT based force measurements are better than the propulsion velocity based stokes drag force estimates. We believe that this study can lay the foundation in designing efficient micro/nanomotors for translational biomedical applications.