Characteristics and release potential of microplastics in municipal solid waste incineration bottom ash

Incineration is an effective method for reducing and safely treating municipal solid waste. However, microplastics (MPs) inevitably remain in the bottom ash, potentially introducing new pollution risks during subsequent treatment processes. This study conducted an analysis of the accumulation and release potential of MPs in bottom ash samples collected from 4 municipal solid waste incineration plants in Zhejiang, China. The results showed that the abundance of MPs ranged from 20 to 118 items g^-1. Remarkably, MPs were found to accumulate predominantly in smaller bottom ash particles below 4.75 mm accounted for up to 70% of the total MPs. Most MPs in the bottom ash were under 100 μm in size, with a majority exceeding 50% being less than 50 μm, typically manifesting as shafts and fibers. In scenarios of secondary crushing, the abundance of MPs increased gradually with the degree of bottom ash crushing. When bottom ash was crushed to a particle size of less than 0.6 mm, the abundance of MPs reached up to 87-901 items g^-1, which is 5-10 times higher than the original bottom ash. It is estimated that the annual release of MPs may reach up to 4.05 × 10¹⁶ particles. Re-incinerating thoroughly crushed bottom ash at 600 °C successfully decomposed the MPs. Mechanical stress can significantly increase the risk of MPs releasing in bottom ash. This risk can be eliminated by using secondary incineration to achieve complete MPs decomposition.