Micronized Shell-Bioaggregates as Mechanical Reinforcement in Organic Coatings

Shells are primarily composed of calcite and aragonite, making the inclusion of micronized shells as bio-based fillers in organic coatings a potential means to enhance the mechanical properties of the layers. A water-based coating was reinforced with 5 wt.% Acanthocardia tuberculata powder, 5 wt.% Mytilus galloprovincialis powder, and 5 wt.% of an LDPE/ceramic/nanoceramic composite. An improvement in abrasion resistance was achieved using micronized seashells, as demonstrated by the Taber test (evaluating both weight loss and thickness reduction). Additionally, Buchholz hardness improved with powders derived from Mytilus galloprovincialis. No significant differences were observed among the samples in terms of color and gloss after 200 h of UV-B exposure. However, the delamination length from the scratch after 168 h of exposure in a salt spray chamber indicated that the addition of particles to the polymeric matrix resulted in premature degradation, likely due to the formation of preferential paths for water penetration from the scratch. This hypothesis was supported by electrochemical impedance spectroscopy measurements, which revealed a decrease in total impedance at 0.01 Hz shortly after immersion in a 3.5% NaCl solution. In conclusion, the particle size and shape of the micronized shells improved abrasion resistance without altering color and gloss but led to a decrease in the coating's isolation properties.