Investigation of the Impact of Single and Double Filtration Systems on Post-Consumer PE Film Waste

Due to the diversity of plastic film waste streams available on the market and the associated variety of contaminants' size and number, the use of melt filtration is necessary. Currently, single and double filtration systems are state of the art in the plastic recycling industry, depending on the application of the produced post-consumer recyclate (PCR). Using PCR for thin films demands small contamination sizes, which are easier to reach using a second filtration step. In the case of relatively clean post-consumer input materials, it must be investigated whether the additional load from the second filter has a counterproductive effect on the material and whether single filtration would be sufficient. For this paper, polyethylene (PE) film waste stemming from a separate post-consumer collection in Austria was processed using an industrial-sized recycling machine with different combinations of filter sizes and systems. Melt flow rate (MFR), ash content, oxidation onset temperature (OOT), and optical contaminant detection were measured to investigate the influence of single and double filtration systems. The investigation showed that, even though the contamination amount and size were reduced, the second filter had a distinct effect on specific properties.