Related Experiment Video
Updated: Jun 14, 2025

Author Spotlight: Standardizing the Development of Amine-Based Silica Composites as CO2 Adsorbents for Direct Air Capture
Published on: September 29, 2023
The dynamic ethylene adsorption on carbon xerogels as a three-way game between porosity, surface chemistry and
Lorena T Pérez-Poyatos1, Sergio Morales-Torres1, Luisa M Pastrana-Martínez1
1NanoTech - Nanomaterials and Sustainable Chemical Technologies, Department of Inorganic Chemistry, Faculty of Sciences, University of Granada, Avda. Fuente Nueva s/n, ES18071 Granada, Spain.
Abstract:
Novel carbon xerogels doped with heteroatoms (O, N, S) were prepared by sol-gel polymerization of resorcinol with heterocyclic aldehydes containing them. All doped materials presented higher O-contents than the reference material prepared with formaldehyde, and significant S- or N-loadings in the corresponding samples. Carbon xerogels were micro-mesoporous and N-doping favoured the formation of mesopores. Their efficiency in the dynamic ethylene adsorption is presented as an interplay between porosity, surface chemistry and humidity. The surface hydrophilicity was also studied by water adsorption assays, a quick adsorption being favoured in microporous samples with hydrophilic O-groups. Breakthrough curves for ethylene adsorption were recorded in both dry and humid conditions and analysed according to the mass transference zone (MTZ). The material behaviour was correlated with the physicochemical properties, elucitating the mechanism of the simultaneous water/ethylene adsorption. The adsorption capacity depended linearly on the microporous characteristics of samples; however, MTZ parameters (efficiency of the column) varied linearly with the electronegativity of the dopant element. Both doping and humidity in the stream hindered the ethylene adsorption kinetic and capacity (up to 33% for N-doped material under humidity compared to undoped-material under dry conditions), due to reduced adsorbate-adsorbent interactions and the accessibility into narrow pores.
More Related Videos
Related Concept Videos
Olefin Metathesis Polymerization: Acyclic Diene Metathesis (ADMET)
Similar to cross-metathesis, ADMET also involves the formation of metallacyclobutane intermediate by [2+2] cycloaddition of one of the double bonds of a terminal diene with...
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control
Electrophilic 1,2- and 1,4-Addition of X2 to 1,3-Butadiene
Electrophilic 1,2- and 1,4-Addition of HX to 1,3-Butadiene
Drying Shrinkage
A portion of this drying shrinkage can be reversed; if the concrete is...

