BRM100 - Celebrating Prof. B. Ramamurthi 1922-2003

A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

The underlying principle of Raman spectroscopy is based on the interaction between light and matter, specifically molecules' inelastic scattering of photons. When a monochromatic beam of light, typically from a laser source, interacts with a sample, most scattered light has the same frequency as the incident light. This is known as Rayleigh scattering.
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...

The root mean square (RMS) value is a measure of the effective or average value of an alternating current (AC) waveform. In AC circuits, the voltage or current waveform constantly changes direction and magnitude, making it difficult to describe with a single value. The RMS value provides a convenient way to calculate the equivalent DC voltage or current that would produce the same heating effect in a resistor as the AC waveform.
Mathematically, the RMS value of an AC waveform is the square root...

A Bipolar Junction Transistor (BJT), specifically a PNP transistor in a common-base configuration, effectively amplifies or switches electronic signals by controlling the flow of charge carriers. This discussion focuses on its operation in the active mode.
In the PNP configuration, the emitter is heavily doped with positive charge carriers (holes), while the base is lightly doped with negative carriers (electrons). This setup allows for a forward bias across the emitter-base junction,...

If a driven oscillator needs to resonate at a specific frequency, then very light damping is required. An example of light damping includes playing piano strings and many other musical instruments. Conversely, to achieve small-amplitude oscillations as in a car's suspension system, heavy damping is required. Heavy damping reduces the amplitude, but the tradeoff is that the system responds at more frequencies. Speed bumps and gravel roads prove that even a car's suspension system is not...

The magnitude and direction of a magnetic field created by a steady current can be calculated using the Biot-Savart law.
Consider a mobile phone battery bank as a source of steady current, which flows through the wire connected between the two. What is the magnitude of the magnetic field created by this current at a field point P?
To estimate the magnitude of the total magnetic field, we first consider a small current element of length dl, at a distance r from the field point. Now the following...