Hippocampal storage and recall of neocortical "What"-"Where" representations

A key question for understanding the function of the hippocampus in memory is how information is recalled from the hippocampus to the neocortex. This was investigated in a neuronal network model of the hippocampal system in which "What" and "Where" neuronal firing rate vectors were applied to separate neocortical modules, which then activated entorhinal cortex "What" and "Where" modules, then the dentate gyrus, then CA3, then CA1, then the entorhinal cortex, and then the backprojections to the neocortex. A rate model showed that the whole system could be trained to recall "Where" in the neocortex from "What" applied as a retrieval cue to the neocortex, and could in principle be trained up towards the theoretical capacity determined largely by the number of synapses onto any one neuron divided by the sparseness of the representation. The trained synaptic weights were then imported into an integrate-and-fire simulation of the same architecture, which showed that the time from presenting a retrieval cue to a neocortex module to recall the whole memory in the neocortex is approximately 100 ms. This is sufficiently fast for the backprojection synapses to be trained onto the still active neocortical neurons during storage of the episodic memory, and this is needed for recall to operate correctly to the neocortex. These simulations also showed that the long loop neocortex-hippocampus-neocortex that operates continuously in time may contribute to complete recall in the neocortex; but that this positive feedback long loop makes the whole dynamical system inherently liable to a pathological increase in neuronal activity. Important factors that contributed to stability included increased inhibition in CA3 and CA1 to keep the firing rates low; and temporal adaptation of the neuronal firing and of active synapses, which are proposed to make an important contribution to stabilizing runaway excitation in cortical circuits in the brain.