Related Experiment Video
Updated: Jun 14, 2025

Key Elements of Photo Attraction Bioassay for Insect Studies or Monitoring Programs
Published on: July 26, 2018
Pollinator response to yellow UV-patterned versus white UV-patternless flower dimorphism in Anemone palmata
N L Rodríguez-Castañeda1, M L Buide2, M Arista1
1Departamento de Biología Vegetal y Ecología, Facultad de Biología, Universidad de Sevilla, Seville, Spain.
Abstract:
Flower colour polymorphisms are uncommon but widespread among angiosperms and can be maintained by a variety of balancing selection mechanisms. Anemone palmata is mostly yellow-flowered, but white-flowered plants coexist in some populations. We analysed the distribution of colour morphs of A. palmata across its range. We also characterised their colours and compared their vegetative and sexual reproductive traits, pollinator attention and fitness. The range of A. palmata is limited to the Western Mediterranean, while white-flowered plants are restricted to Portugal and SW Spain, where they occur at low proportions. Yellow flowers have a characteristic UV pattern, with a UV-absorbing centre and UV-reflecting periphery, which is absent in the white morph. Colour features of both morphs were highly delineated, making it easy for pollinators to distinguish them. Both morphs were protogynous, with the same duration of sexual stages, and the main floral traits related to pollinator attraction, apart from flower colour, were similar. Hymenoptera and Diptera were the main pollinators, showing preference for the yellow morph, clear partitioning of pollinator groups between the two colour morphs and a marked constancy to flower colour during foraging. Both morphs combined clonal propagation with sexual reproduction, but sexual reproductive potential was lower in white-flowered plants. Finally, female fitness was higher in the yellow morph. Pollinator partitioning and colour constancy could maintain this polymorphism, despite the lower visitation rate and fitness of white-flowered plants, which could facilitate their clonal propagation.
More Related Videos
Related Concept Videos
Pollination and Flower Structure
Mate Choice
Frequency-dependent Selection
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used;...
Predator-Prey Interactions

