Related Experiment Video
Updated: Jun 14, 2025
A Complete Method for Evaluating the Performance of Photocatalysts for the Degradation of Antibiotics in Environmental Remediation
Published on: October 6, 2022
Preparation of Multistage Pore TS-1 with Enhanced Photocatalytic Activity, Including Process Studies and Artificial
Yulan Zhang1, Yubing Liu1, Yuan Wei1
1Key Laboratory of Low Carbon Energy and Chemical Engineering of Gansu Province, College of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, China.
Abstract:
Antibiotic residues have been found in several aquatic ecosystems as a result of the widespread use of antibiotics in recent years, which poses a major risk to both human health and the environment. At present, photocatalytic degradation is the most effective and environmentally friendly method. Titanium silicon molecular sieve (TS-1) has been widely used as an industrial catalyst, but its photocatalytic application in wastewater treatment is limited due to its small pores and few active sites. In this paper, we report a method for preparing multistage porous TS-1 with a high specific surface area by alkali treatment. In the photocatalytic removal of CIP (ciprofloxacin) antibiotic wastewater experiments, the alkali-treated catalyst showed better performance in terms of interfacial charge transfer efficiency, which was 2.3 times higher than that of TS-1 synthesized by the conventional method, and it was found to maintain better catalytic performance in the actual water source. In addition, this research studied the effects of solution pH, contaminant concentration, and catalyst dosage on CIP degradation, while liquid chromatography-mass spectrometry (LC-MS) was used to identify intermediates in the degradation process and infer possible degradation pathways and the toxicity of CIP, and its degradation product was also analyzed using ECOSAR 2.2 software, and most of the intermediates were found to be nontoxic and nonharmful. Finally, a 3:5:1 artificial neural network model was established based on the experiments, and the relative importance of the influence of experimental conditions on the degradation rate was determined. The above results confirmed the feasibility and applicability of photocatalytic treatment of wastewater containing antibiotics using visible light excitation alkali post-treatment TS-1, which provided technical support and a theoretical basis for the photocatalytic treatment of wastewater containing antibiotics.
