Related Experiment Video
Updated: Jun 14, 2025
3D Printing Model of a Patient's Specific Lumbar Vertebra
Published on: April 14, 2023
High-fidelity 3D modelling of the lumbar dorsal rami
John Tran1,2,3, Emma Campisi3, Alexandria Roa Agudelo1,2
1Department of Physical Medicine and Rehabilitation, Parkwood Institute, London, Ontario, N6C 0A7, Canada.
Objective:
Lumbar medial branch denervation is commonly used to treat chronic facetogenic low back pain. Controversy exists regarding risk to adjacent neural structures. The objectives of this cadaveric study were to: (1) dissect, digitize, and model in 3D the branches of the first (L1) to fifth (L5) lumbar dorsal rami located near the junction of the transverse process and lateral neck of the superior articular process; and (2) quantify the minimal distance between the lateral/intermediate and medial branches at the anterior quarter and midpoint of the lateral neck of the superior articular process.
Design:
Eighteen formalin-embalmed specimens were dissected, digitized and modeled in 3D. The high-fidelity 3D models were used to compare branching patterns and quantify the mean minimal distance between the lateral/intermediate and medial branches of the lumbar dorsal ramus at the anterior quarter and midpoint of the lateral neck of the superior articular process. A Two-way ANOVA was performed to determine if difference of mean distances was significant.
Results:
There was variability in the branching pattern of the lumbar dorsal rami. In 46 cases (51.1%) the lumbar dorsal ramus divided into 2 branches, in 41 cases (45.6%) into 3, and in 3 cases (3.3%) 4. The mean minimal distance between the lateral/intermediate and medial branches was significantly greater at the midpoint (3.2 ± 2.5 mm) than the anterior quarter (1.2 ± 1.8 mm) of the lateral neck of superior articular process.
Conclusion:
Minimal distance measurements between the branches of the lumbar dorsal rami at the anterior quarter and midpoint of the lateral neck of the superior articular process were computed. When placing the distal end of the needle tip at the anterior quarter of the lateral neck of the superior articular process, the smaller mean minimal distance between the branches suggests there is a greater risk for inadvertent denervation of the lateral/intermediate branches. Further anatomical and clinical investigations are required.
