Comparative chemometric modeling of fresh and dry cannabis inflorescences using FT-NIR spectroscopy: Quantification...

Cannabis sativa L. inflorescences are rich in cannabinoids and terpenes. Traditional chemical analysis methods for cannabinoids and terpenes, such as liquid and gas chromatography (using UV or MS detectors), are expensive and time-consuming.

This study explores the use of Fourier transform near-infrared (FT-NIR) spectroscopy combined with chemometric approaches for classifying cannabis chemovars and predicting cannabinoid and terpene concentrations for the first time in freshly harvested (wet) cannabis inflorescence. The study also compares the performance of FT-NIR spectroscopy on wet versus dry cannabis inflorescences.

Spectral data from 187 samples across seven cannabis chemovars were analyzed using partial least squares-discriminant analysis (PLS-DA) and partial least squares-regression (PLS-R) models.

The PLS-DA models effectively classified chemovars and major classes using only two latent variables (LVs) with minimal overfitting risk, with sensitivity, specificity, and accuracy values approaching 1. Despite the high water content in wet cannabis inflorescence, the PLS-R models demonstrated good to excellent predictive capabilities for nine cannabinoids and eight terpenes using FT-NIR spectra for the first time, achieving cross-validation and prediction R-squared values greater than 0.7, ratio of performance to interquartile range (RPIQ) exceeding 2, and a RMSECV/RMSEC ratio below 1.24. However, the low-cannabidiolic acid submodel and (-)-Δ9-trans-tetrahydrocannabinol model showed poor predictive performance. Some cannabinoid and terpene prediction models in wet cannabis inflorescence exhibited lower predictive capabilities compared with previously published models for dry cannabis inflorescence.

These findings suggest that FT-NIR spectroscopy can be a viable rapid on-site analytical tool for growers during the inflorescence flowering stage.