Related Experiment Video

Updated: Jun 13, 2025

Automated Analysis of Dynamic Ca2+ Signals in Image Sequences
06:49

Automated Analysis of Dynamic Ca2+ Signals in Image Sequences

Published on: June 16, 2014

17.1K

Improvement and application of back random response detection: Based on cumulative sum and change point analysis

Yuxin Li1, Qipeng Chen2, Yaojie Gao3

  • 1Department of Psychology, Nanjing University, Nanjing, Jiangsu, China.

Behavior Research Methods
|September 10, 2024
PubMed

Keywords:
Back random responseChange point analysisCumulative sumPerson-fit statistics

More Related Videos

Design and Analysis for Fall Detection System Simplification08:05

Design and Analysis for Fall Detection System Simplification

Published on: April 6, 2020

10.6K
Measurement & Analysis of the Temporal Discrimination Threshold Applied to Cervical Dystonia10:05

Measurement & Analysis of the Temporal Discrimination Threshold Applied to Cervical Dystonia

Published on: January 27, 2018

9.7K

Related Concept Videos

Detection of Gross Error: The Q Test01:00

Detection of Gross Error: The Q Test

When one or more data points appear far from the rest of the data, there is a need to determine whether they are outliers and whether they should be eliminated from the data set to ensure an accurate representation of the measured value. In many cases, outliers arise from gross errors (or human errors) and do not accurately reflect the underlying phenomenon. In some cases, however, these apparent outliers reflect true phenomenological differences. In these cases, we can use statistical methods...
5.7K
Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and...
201
Random Error01:04

Random Error

Random or indeterminate errors originate from various uncontrollable variables, such as variations in environmental conditions, instrument imperfections, or the inherent variability of the phenomena being measured. Usually, these errors cannot be predicted, estimated, or characterized because their direction and magnitude often vary in magnitude and direction even during consecutive measurements. As a result, they are difficult to eliminate. However, the aggregate effect of these errors can be...
848
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
6.0K
Sampling Continuous Time Signal01:11

Sampling Continuous Time Signal

In signal processing, a continuous-time signal can be sampled using an impulse-train sampling technique, followed by the zero-order hold method. Impulse-train sampling involves the use of a periodic impulse train, which consists of a series of delta functions spaced at regular intervals determined by the sampling period. When a continuous-time signal is multiplied by this impulse train, it generates impulses with amplitudes corresponding to the signal's values at the sampling points.
In the...
218
Censoring Survival Data01:09

Censoring Survival Data

Survival analysis is a statistical method used to analyze time-to-event data, often employed in fields such as medicine, engineering, and social sciences. One of the key challenges in survival analysis is dealing with incomplete data, a phenomenon known as "censoring." Censoring occurs when the event of interest (such as death, relapse, or system failure) has not occurred for some individuals by the end of the study period or is otherwise unobservable, and it might have many different...
72