Related Experiment Video
Updated: Jun 13, 2025

Atom Probe Tomography Analysis of Exsolved Mineral Phases
Published on: October 25, 2019
Titanite petrochronological data across the continental crust section exposed in Val d'Ossola (Ivrea-Verbano Zone,
Stefania Corvò1,2, Andrew R C Kylander-Clark3, Antonio Langone1,2
1Department of Earth and Environmental Sciences, University of Pavia, Pavia, Italy.
Abstract:
Titanite-bearing calc-silicates and mafic gneisses, metamorphosed under amphibolite- to granulite-facies conditions, crop out in Val d'Ossola area (Ivrea-Verbano Zone, Italy). The Ivrea-Verbano Zone represents an exhumed section of the pre-Alpine middle to lower continental crust which escaped the Alpine subduction, thus provides a unique opportunity to study continental crustal processes and evolution. Among several samples, three, collected from different locations, were chosen for detailed analyses of titanite. Petrochronology of titanite was performed with Laser ablation split-stream (LASS) technique on petrographic thin sections. Petrochronological results on titanite do not define clear correlations with chemistry except for one sample. Rare earth elements (REE) patterns of titanite from the three samples are apparently different in terms of average concentration (i.e., lower or upper 1000 times CI), shapes and occurrence or absence of Eu negative anomaly. Al/Fe vs ΣLREE and Fe content vs Zr/Y plots show that the studied samples coincide with metamorphic rock field deriving from calc-silicates and mafic protoliths, as previously demonstrated in literature. Any compilations of petrochronological data on titanite from the metamorphic volcano-sedimentary sequence of Val d'Ossola can be found in literature. Therefore, these data represent a new insight on an accessory mineral phase whose significance and scientific interest are rising in the last years. Future studies of the evolution of these kinds of rock, widespread in the high-grade metamorphic basements, will benefit from these data as a term of comparison.
More Related Videos
Related Concept Videos
Quarrying of Stone
One common method involves using a diamond belt saw to cut large blocks from the quarry face. These blocks can be about 50 feet long and 12 feet high. After the initial vertical cut, drilling is performed at the base of the...
Inductively Coupled Plasma-Mass Spectrometry (ICP-MS): Interferences
The Fossil Record
Minerals
Major...
Isothermal Processes
An ideal gas can also undergo isothermal expansion or compression.
For example, consider 1 mole of an ideal gas inside an isolated cylinder at initial volume V...
Inductively Coupled Plasma–Mass Spectrometry (ICP–MS): Overview

