High efficiency wide gap Cu(In,Ga)Se₂ solar cells: Influence of buffer layer characteristics

Wide-gap Cu(In,Ga)Se₂ (CIGS) solar cells exhibit a superior match to the solar spectrum, resulting in a higher ideal efficiency (E _ff). However, in reality, their device E _ff is lower than that of narrow-gap CIGS solar cells. This study aims to identify the factors that limit the performance enhancement of wide-gap CIGS solar cells, focusing on the characteristics of the buffer layer. The influence of the thickness and doping concentration of the CdS layer on the built-in electric field and interfacial recombination of the heterojunction has been investigated through simulation. The simulation results indicate that when the doping concentration of the CdS layer is lower than or similar to that of the CGS layer, decreasing the thickness of the CdS layer (e.g., 10 nm) is beneficial for improving device performance. However, if it is higher than that of the CGS layer, increasing the thickness of the CdS layer (e.g., 50 nm) is conducive to improving device performance. The thickness of the CdS layer that maximizes the E _ff of the wide-gap CGS device should be approximately 50 nm, and its doping concentration should be higher than that of the CGS layer. This optimization can simultaneously enhance the built-in electric field of the heterojunction and minimize its interfacial recombination, thereby improving the open-circuit voltage and E _ff of wide-gap CGS devices.