Related Experiment Video

Updated: Jun 13, 2025

Measuring Light-Switching Behavior Using an Occupancy and Light Data Logger
05:50

Measuring Light-Switching Behavior Using an Occupancy and Light Data Logger

Published on: January 16, 2020

5.8K

The longitudinal relationship between tourism, electricity consumption, and CO2 emissions

Rizwan Munir1, Tahir Abbas2, Liaqat Ali Waseem3

  • 1School of Statistics and Data Science, Jiangxi University of Finance and Economics, Nanchang, China.

Heliyon
|September 17, 2024
PubMed
Abstract

Keywords:
ARDLDOLSFMOLSForeign direct investmentIntercountryal tradePakistanTourism industryelectricity use

More Related Videos

Evaluating the Effect of Roadside Parking on a Dual-Direction Urban Street14:55

Evaluating the Effect of Roadside Parking on a Dual-Direction Urban Street

Published on: January 20, 2023

3.2K
Measurements of CO2 Fluxes at Non-Ideal Eddy Covariance Sites09:05

Measurements of CO2 Fluxes at Non-Ideal Eddy Covariance Sites

Published on: June 24, 2019

7.9K

Related Concept Videos

Calculating and Interpreting the Linear Correlation Coefficient01:11

Calculating and Interpreting the Linear Correlation Coefficient

The correlation coefficient, r, developed by Karl Pearson in the early 1900s, is numerical and provides a measure of strength and direction of the linear association between the independent variable, x, and the dependent variable, y. Hence, it is also known as the Pearson product-moment correlation coefficient. It can be calculated using the following equation:
5.9K
Correlation01:09

Correlation

In statistics, two variables are said to be correlated if the values of one variable are associated with the other variable. Depending on the relationship between two variables, correlation can be of three types– positive correlation, negative correlation, and zero correlation.
Two variables, for example, a and b, are said to be positively correlated if both variables move in the same direction. In other words, a positive correlation exists between two variables, a and b, if:
11.7K
Electrical Energy01:10

Electrical Energy

Using electric appliances for a longer period of time consumes more electrical energy and results in a higher electric bill. The energy produced by the transfer of electrons from one point to another is known as electrical energy. If power is delivered at a constant rate, the electrical energy can be defined as the product of power used by the device for a period of time. The energy unit on electric bills is the kilowatt-hour, where one kilowatt-hour is equivalent to 3.6 × 106 joules.
1.2K
Trophic Efficiency00:46

Trophic Efficiency

Trophic level transfer efficiency (TLTE) is a measure of the total energy transfer from one trophic level to the next. Due to extensive energy loss as metabolic heat, an average of only 10% of the original energy obtained is passed on to the next level. This pattern of energy loss severely limits the possible number of trophic levels in a food chain.
20.3K
Energy Diagrams - II01:10

Energy Diagrams - II

Energy diagrams are important to understand the dynamics of a system. The topology of an energy diagram helps illustrate the equilibrium points of the system.
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...
4.6K
Regression Analysis01:11

Regression Analysis

Regression analysis is a statistical tool that describes a mathematical relationship between a dependent variable and one or more independent variables.
In regression analysis, a regression equation is determined based on the line of best fit– a line that best fits the data points plotted in a graph. This line is also called the regression line. The algebraic equation for the regression line is called the regression equation. It is represented as:
5.7K