National Park visitors perceive benefits for themselves and wildlife under blended red-white outdoor lighting
Kurt Fristrup1, Zachary D Miller2, Jennifer Newton3
1Division of Natural Sounds and Night Skies, National Park Service, 1201 Oakridge Drive, Suite 100, Fort Collins, CO, 80525, USA. Kurt.Fristrup@colostate.edu.
Abstract:
Visitors to Colter Bay Village in Grand Teton National Park were surveyed to elicit their evaluations of experimental outdoor lighting conditions. Luminaires capable of dimming and switching between two LED modules (white, blended red-white) were installed in street and parking areas. The blended red-white lamps consisted of 30 narrowband LED with a peak wavelength 623 nm and two 3000 K white LEDs. Similar "red" lamps were previously shown to reduce impacts to bats and insects. The white and red lamps were closely matched for luminance. Measured horizontal illuminance at survey locations had an interquartile range from 0.63 to 3.82 lx. The red lamps produced lower perceived brightness (VB2(λ)), even after reflection off asphalt, yet survey participants expressed higher ratings for visual comfort and safety under red lighting. Surveys conducted earlier in the evening, with higher levels of predicted solar and measured horizontal illuminance, rated higher on visual comfort and safety, though these correlations were not as strong as the effect of lamp color. Streetlight ratings and support for lighting that protected natural resources were not contingent upon age or gender. Survey participants assessed red lighting as more protective of the environment. These results demonstrate that outdoor lighting designed to reduce ecological impacts can yield superior nocturnal experience for pedestrians.
More Related Videos
Related Concept Videos
Naturalistic Observations
Photoreceptors and Visual Pathways
Photoreceptors and Plant Responses to Light
Color Vision
Factors Affecting Perception
An illustrative example of a perceptual set is the scenario where an airline pilot told...
Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...


