Related Experiment Video
Updated: Jun 12, 2025

An Inertial Measurement Unit Based Method to Estimate Hip and Knee Joint Kinematics in Team Sport Athletes on the Field
Published on: May 26, 2020
External Load of Different Length Microcycles and Relationships with Match Running Performance in Youth Football
Yiannis Michailidis1, Vasileios Kanaras1, Athanasios Mandroukas1
1Aristotle University of Thessaloniki.
Abstract:
The purpose of this study was to investigate: a) the differences in external load (EL) during microcycles with four (MIC4) and five training (MIC5) sessions, b) to explore the ratio of weekly training load to the load of the subsequent match, and c) to explore possible correlations between the EL of the MIC4 or MIC5 with the running performance of football players in the following match. The study involved 20 elite youth football players from a team that won the championship in their category that year (age, 16.4 ± 0.3 years). The EL was tracked via GPS in 8 MIC4 and 10 MIC5. Running performance in subsequent matches was also recorded. Two by two ANOVA was employed to compare parameters between MIC5 and MIC4 and Pearson correlation test was applied to examine potential correlations between the training load parameters. The results showed that MIC5 had significantly greater external load in distance parameters in zones 4 & 5, total distance, and decelerations. Differences in running performance in matches were observed only for accelerations (p = .028) and decelerations (p = .02). The ratio of training/match load was lower in all parameters in MIC4 compared to MIC5 but exceeded the match load. Large negative correlations were observed for accelerations and decelerations. In conclusion, additional training in MIC5 increases the load without affecting running performance in the match. Attention should be given to accelerations and decelerations, as their volume can easily increase with the use of small-sided games in training.
Related Concept Videos
Impact Loading
In cases of elastic deformation,...
Relation Between the Distributed Load and Shear
Social Facilitation
Eccentric Loading
Relationship Formation
Coefficient of Correlation
If you suspect a linear relationship between x and y, then r can measure how strong the linear relationship is.
What the VALUE of r tells us:
The value of r is always between –1 and +1: –1 ≤ r ≤ 1.
The size of the correlation r indicates the...

