Related Experiment Video
Updated: Jun 12, 2025
High-Throughput Dissociation and Orthotopic Implantation of Breast Cancer Patient-Derived Xenografts
Published on: December 20, 2024
A Customized 3D-Printed Bolus for High-Risk Breast Cancer with Skin Infiltration: A Pilot Study
Silvia Takanen1, Anna Ianiro2, Paola Pinnarò1
1Radiation Oncology Department, IRCCS Regina Elena National Cancer Institute, 00144 Rome, Italy.
Background:
In high-risk breast cancer patients with skin infiltration, the administration of a uniform dose to superficial tissues is fundamental in order to reduce local skin relapse. A personalized bolus may prevent the potential inadequate dose distribution of a standard bolus due to air gaps between the bolus and the skin. In this pilot study, we introduced into clinical practice the use of a personalized 3D-printed bolus filled with ultrasound transmission gel.
Methods:
Seven patients undergoing radiotherapy after mastectomy were selected. A 3D-printed bolus dosimetric assessment was performed with MOSFET dosimeters on an anthropomorphic phantom and, subsequently, on three selected cases with increasing bolus shape irregularity. Acute/late toxicity and local control were assessed.
Results:
Overall, for the clinical cases, the percentage median difference between the measured and calculated doses was -2.7% (-7.0-4.9%). The median follow-up was 21 months. After two years, one patient showed G2 pain, one patient manifested G1 telangiectasia, one patient showed G1 hyperpigmentation, and two patients had no relevant toxicity.
Conclusions:
A personalized 3D-printed bolus filled with ultrasound gel may easily reproduce the standard bolus' consistency and provide accurate coverage of the target area with tolerable acute/late toxicity grades. This is a pilot study, and further investigations are needed.
