Population density as the attractor of business to the place

Katarzyna Kopczewska1, Maria Kubara2, Mateusz Kopyt2

  • 1Faculty of Economic Sciences, University of Warsaw, Ul. Dluga 44/50, 00-241, Warsaw, Poland. kkopczewska@wne.uw.edu.pl.

Scientific Reports
|September 27, 2024
PubMed

Related Concept Videos

Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
14.6K
Population Growth00:57

Population Growth

Population size is dynamic, increasing with birth rates and immigration, and decreasing with death rates and emigration. In ideal conditions with unlimited resources, populations can increase exponentially, which plots as a J-shaped growth rate curve of population size against time. This type of curve is characteristic of newly-introduced invasive species, or populations that have suffered catastrophic declines and are rebounding.
25.0K
Bulk Density of Aggregate01:22

Bulk Density of Aggregate

Bulk density refers to the mass of aggregate particles that would fill a unit volume. The concept of bulk density originates from the inability to pack aggregate particles in a manner that completely eliminates void spaces. Hence, the term bulk refers to the volume that encompasses both the aggregates and the voids. This measurement is crucial when aggregates are batched by volume and is used to convert quantities by mass to volume.
Most natural mineral aggregates, like sand and gravel,...
419
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
13.0K
Poisson Probability Distribution01:09

Poisson Probability Distribution

A Poisson probability distribution is a discrete probability distribution. It gives the probability of a number of events occurring in a fixed interval of time or space if these events happen at a known average rate and independently of the time since the last event. For example, a book editor might be interested in the number of words spelled incorrectly in a particular book. It might be that, on average, there are five words spelled incorrectly in 100 pages. The interval is 100 pages.
The...
7.8K
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
3.8K