Residual Stress Analysis in Linear Friction Welded Ti17

Residual stresses with a complex distribution are generated after linear friction welding, which affects the service performance of the weldment. In this work, a numerical model for linear-friction-welded Ti17 (Ti-5Al-2Sn-2Zr-4Mo-4Cr) was developed to investigate the evolution of residual stresses and the effect of welding parameters on residual stresses. Additionally, a method for predicting internal residual stresses was constructed. The results indicate that the residual stresses near the contact interface are largest in the oscillatory direction, peaking at ~661 MPa at 2 mm away from the contact interface. The evolution of stresses is not only related to the inhomogeneous thermal gradient, but also to the forging force. And the stress distribution essentially stabilizes within the duration of the forging force applied. Increasing the amplitude and frequency results in higher peaks of tensile residual stresses and a more concentrated distribution. Conversely, increasing the forging force only reduces the magnitude of the residual stresses. The developed prediction method, based on the similarity of internal residual stress distributions, facilitates the prediction of internal residual stresses using measured surface residual stresses.