Study on the Flexural Performance of Ultrahigh-Performance Concrete-Normal Concrete Composite Slabs

In recent years, there have been an increasing number of examples of using ultrahigh-performance concrete (UHPC) as a pavement layer to form an ultrahigh-performance concrete-normal concrete (UHPC-NC) composite structure to improve the bearing capacity of bridges. In order to study the flexural performance of this kind of structure, this research studied the flexural performance of UHPC-NC composite slabs, with UHPC in the compression zone, using experiments, numerical simulation, and theoretical analysis. The results showed the following. Firstly, after the UHPC-NC interface had been chiseled, there was no obvious slip between the two materials during the test, and the composite plate was always subjected to synergistic stress. Secondly, the composite slabs in the compression zone of the UHPC were all subjected to bending failure, and the cooperative working performance of each part under the bending load was good, indicating that the composite slab had a unique failure mode and a high bearing capacity. Thirdly, increasing the thickness of the UHPC significantly improved the flexural capacity of the composite plate, and the maximum increase was about 15%. Increasing the reinforcement ratio of the tensile steel rebars also had an increasing effect, with a maximum increase of about 181%. Finally, the proposed formula for calculating the flexural capacity of composite slabs with UHPC in the compression zone could accurately predict the bearing capacity of said slabs. The calculated results were in good agreement with the experimental values, and the error was small.