Related Experiment Video
Updated: May 5, 2026
Quantification of Orofacial Phenotypes in Xenopus
Published on: November 6, 2014
Assessment of the Vertical Dimension of Occlusion Using Palm Width and Finger Length
Cecilia Bacali1, Mariana Constantiniuc1, Antarinia Craciun1
1Department of Prosthodontics and Dental Materials, "Iuliu Hațieganu" University of Medicine and Pharmacy, 400006 Cluj-Napoca, Romania.
Abstract:
Background and Objectives: The vertical dimension of occlusion's (VDO) assessment is a highly important issue in the everyday dentist's practice. Patients with unstable occlusion, lost occlusal stops, extensive tooth loss in the lateral area, or complete edentulism need a proper assessment of the VDO before the prosthetic restoration is carried out. Subjective and objective methods were used over time for the restoration of VDO. The study aimed to investigate the possible correlation between finger length, palm width and the vertical dimension of occlusion. Materials and Methods: Assessment of the VDO for 236 subjects, Romanian and French dental students, was performed using the Willis Bite Gauge. The left hand of the subjects was scanned using a flat-bed scanner, and then measurements of palm width and finger length were carried out for each subject. Comparison between VDO values and finger length/palm width was conducted using one-way ANOVA and Student t-Test. Results: Higher VDO average values were found in French subjects compared with Romanian students. The same results were found according to gender; in both female and male subjects, lower values of VDO were found in the Romanian group. Higher values were obtained for women within each group when comparing to men. Statistically significant correlations of the analyzed parameters and VDO values were found. Higher statistical correlations of the studied variables were found for men compared to women in both groups. The highest statistical correlation was obtained between the VDO and the palm width measured at the fingerbase, followed by the middle finger length. Conclusions: The results showed the highest statistical correlation between the vertical dimension of occlusion and the palm width measured at the fingers' base. Statistical correlations were also found between the VDO and the middle finger length. Simple formulas using finger length/palm width can be used for a rapid VDO determination.
Related Concept Videos
01:25Assessment of apical radial pulse
The A-R pulse assessment involves simultaneous evaluation of the apical and radial pulses. When the apical and radial pulse rates vary, this assessment helps identify a pulse deficit.
Pre-Procedural Preparation
01:30Assessment of Airway, Skin Color, and Use of Accessory Muscles
Introduction
The initial evaluation of a patient's respiratory system...
01:29Assessment of Ventilation II: Respiratory Depth and Rhythm
Respiratory depth measures the volume of air inhaled or exhaled during a breath. It can vary from shallow to deep and typically remains consistent when a person is at rest or asleep. Occasionally, individuals will automatically inhale deeply, known as sighing, which inflates the lungs with more air than normal breathing.
To assess respiratory depth, observe the degree of chest excursion or movement:
01:23Assessment of the Abdomen III: Palpation
01:26Assessment of the Mouth
Mouth Inspection
The inspection begins with visually examining the mouth for symmetry, color, and size.
01:27Assessment of the Cardiovascular System III: Palpation
Jugular Venous Pressure (JVP) Measurement
Position the patient at a thirty- to forty-five-degree angle or in a semi-fowler's position. Look for the highest point of pulsation in the internal jugular vein and measure the vertical distance to the angle of Loius or sternal angle. A normal JVP is 3-4 cm above...