Investigation of new analysis methods for simultaneous and rapid identification of five different microplastics using...

Microplastic (MP) pollution in water has become one of the most important global problems of our time. The development of appropriate and rapid analysis techniques is of great importance at the beginning of the studies aimed at solving this problem. In the presented study, in order to perform the qualitative and quantitative analysis of MP forms of polyamide (PA), polyethylene (PE), polypropylene (PP), polystyrene (PS), and polyethylene terephthalate (PET), which are known to be most abundant in water, in a fast and easy way, new Attenuated Total Reflectance-Fourier Transform Infrared (ATR-FTIR) spectroscopy methods were tried to be developed by utilizing chemometric methods. While principal component analysis (PCA) was applied for qualitative analyses, partial least squares (PLS) models were created for quantitative analyses. Raw, 1st, and 2nd order derivatives of all spectra and their spectra with different levels of smoothing points were taken and 24 different chemometric models were created for each MP. In interpreting the statistical performances of the developed PCA and PLS models, different parameters were used. According to the obtained results, the qualitative discrimination of all polymer types was successfully achieved. It was determined that the PLS models developed for the quantitative determination of mixtures consisting of different concentrations of MP types could not be at the desired level. However, it was determined that the PLS models developed for PA, PE, PP, and PET, where the normal spectrum was used, could give quantitatively accurate results, albeit partially.