Swelling and Degrafting of Poly(3-sulfopropyl methacrylate) Brushes

Upon exposure to a good solvent, polymer brushes prepared via surface-initiated polymerization can undergo degrafting via cleavage of bonds that anchor the polymer tethers to the underlying substrate. As polymer brushes are often used in a solvent swollen state, this has implications for the longevity of these polymer coatings. Improving the fundamental understanding of this process is thus also of practical importance. It is believed that degrafting is the consequence of tension amplification at the bonds that anchor the polymer grafts, which is driven by swelling of the polymer brush film. Taking advantage of the sensitivity of the swelling behavior of poly(3-sulfopropyl methacrylate) (PSPMA) brushes toward changes in ionic strength, this study has investigated the degrafting behavior of these brushes in aqueous media at different LiCl and NaCl concentrations. The aim of these experiments was to investigate whether the rate constant of the degrafting process was correlated with the swelling ratio of the PSPMA brushes. The experiments show that in aqueous LiCl solutions, the initial rate constant of the degrafting process is correlated with the swelling ratio of the PSPMA brush. This observation represents a first example of the correlation between these two parameters for hydrophilic polymer brushes in aqueous media and supports the idea that degrafting is a mechanochemical process driven by a swelling-induced tension at the polymer-substrate interface.