Related Experiment Video
Updated: Jun 11, 2025

Speciation and Bioavailability Measurements of Environmental Plutonium Using Diffusion in Thin Films
Published on: November 9, 2015
Factors influencing the dissolution rate of radon gas in water
Xiongjie Zhang1, Li Feng2, Ye Zhang3
1National Key Laboratory of Uranium Resources Exploration-Mining and Nuclear Remote Sensing, Nanchang, 330013, Jiangxi, China; Engineering Research Center of Nuclear Technology Application(East China University of Technology), Nanchang, 330013, Jiangxi, China.
Abstract:
Measurements of radon (222Rn) in water are widely utilized across various disciplines, including technology, medicine, exploration, and ecological preservation. For accurate radon measurements in water, the availability of a standardized radon solution is essential. Researchers have predominantly concentrated on the radon concentration in water (RCW) once radon distribution equilibrium is achieved, rather than the rate of radon dissolution prior to equilibrium, in the development of standard radon solutions. This makes the preparation speed of the calibration standards radon solution slow, which seriously restricts the research and development of the standard device. The purpose of this paper is to investigate the correlation between the rate of radon dissolution and both the concentration of gaseous radon and the stirring speed. Four conclusions have been derived through univariate analysis. ➀ The radon concentration in water (RCW) increases with the duration of radon dissolution, eventually reaching a state of equilibrium. ➁ The increase in gas radon concentration correlates with a simultaneous rise in the rate of radon dissolution, while the time required for radon distribution equilibrium remains constant. ➂ The augmentation of the stirring speed enhances the rate of radon dissolution, Concurrently reducing the time needed for RCW to reach equilibrium.➃ When the stirring speed is excessively high, it results in substantial fluctuations in both RCW and the rate of radon dissolution. Consequently, when employing this method for the preparation of radon solutions, it is advisable to regulate the duration of radon dissolution to 30 min at a rate of 380 rad/min and 10 min at a rate of 480 rad/min. This regulation ensures the attainment of precise concentrations. Under conditions of environmental stability, manipulation of gas radon concentration alone proves sufficient for adjusting RCW . These empirical findings furnish a robust foundation for the efficient preparation of standardized radon solutions and the requisite apparatus, essential for the calibration and accuracy of radon measurement instruments.
Related Concept Videos
Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model
Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Theories of Dissolution: Diffusion Layer Model
This process starts with a thin layer, saturated with the drug, forming at the interface between the solid and liquid. The solute then diffuses from this layer into the main solution. The Noyes-Whitney equation suggests that the rate of dissolution relies on the diffusion...
Factors Affecting Dissolution: Drug pKa, Lipophilicity and GI pH
A drug's pKa and the pH of the gastrointestinal (GI) tract play crucial roles...
Factors Affecting Dissolution: Drug Permeability, Stability and Stereochemistry

