Related Experiment Video
Updated: Jun 11, 2025

Influence of Hybrid Perovskite Fabrication Methods on Film Formation, Electronic Structure, and Solar Cell Performance
Published on: February 27, 2017
Suppressing Hole Accumulation Through Sub-Nanometer Dipole Interfaces in Hybrid Perovskite/Organic Solar Cells for
Min-Ho Lee1, Min Seok Kim1, Yu Jin Lee2
1School of Electrical Engineering (EE), Korea Advanced Institute of Science and Technology (KAIST), 291 Daehak-ro, Yuseong-gu, Daejeon, 34141, Republic of Korea.
Abstract:
The potential of hybrid perovskite/organic solar cells (HSCs) is increasingly recognized owing to their advantageous characteristics, including straightforward fabrication, broad-spectrum photon absorption, and minimal open-circuit voltage (VOC) loss. Nonetheless, a key bottleneck for efficiency improvement is the energy level mismatch at the perovskite/bulk-heterojunction (BHJ) interface, leading to charge accumulation. In this study, it is demonstrated that introducing a uniform sub-nanometer dipole layer formed of B3PyMPM onto the perovskite surface effectively reduces the 0.24 eV energy band offset between the perovskite and the donor of BHJ. This strategic modification suppresses the charge recombination loss, resulting in a noticeable 30 mV increase in the VOC and a balanced carrier transport, accompanied by a 5.0% increase in the fill factor. Consequently, HSCs that achieve power conversion efficiency of 24.0% is developed, a new record for Pb-based HSCs with a remarkable increase in the short-circuit current of 4.9 mA cm-2, attributed to enhanced near-infrared photon harvesting.

