Spark Plasma Sintering of Complex Metal and Ceramic Structures Produced by Material Extrusion

Alternative approaches to laser fusion for the additive manufacturing (AM) of metals are often hampered by the need for long sintering cycles. Typical sintering cycles require heating at temperatures above 80% of the melting point for several hours. The process is time- and energy-consuming, particularly when high-melting materials are involved. Applying pressure can drastically reduce the time and temperature required for densification. Recently, a particular kind of pressure-assisted sintering process known as spark plasma sintering (SPS) or field-assisted sintering (FAST) received considerable attention in academia and industry due to its ability to enhance densification. However, conventional SPS/FAST techniques cannot be directly applied to the densification of objects presenting a complex geometry. This work shows how a modified SPS/FAST setup, operating in a pseudoisostatic mode, can be used for debinding and sinter objects produced by material extrusion. This approach can be applied to metals and metal-based and ceramic-based composites when their geometry does not include closed cavities. Depending on the characteristics of the pressure-transfer medium, some level of anisotropy in the volume reduction associated with the densification can be observed. Still, it can easily be corrected by appropriately compensating sintering deformation during printing. Using this approach, the time required for the debinding and sintering can be reduced considerably. It represents an alternative approach to the AM of a wide range of inorganic materials characterized by a relatively low-cost, high material flexibility, and low environmental impact.