Bending properties and damage evolution of fiber-reinforced aeolian sand backfill materials

Backfilling is a promising measure for controlling surface subsidence in mined-out areas and disposing solid wastes from the mineral processing, there are increasing demands of enhanced toughness and anti-cracking properties of backfill materials to prolong the service life under the complex loads. In this study, polypropylene (PP) fibers were employed to improve performance of backfills, four-point bending and uniaxial compression tests were conducted to investigate the failure process and damage evolution of fiber-reinforced aeolian-sand backfill materials (FABs) using Digital Image Correlation (DIC) and Acoustic Emission (AE) techniques. The results show that the compressive strength tends to decrease with the increasing fiber volume fractions, while the four-point bending strength shows a tendency to increase initially and then decrease, and the optimum volume fraction of PP fiber is 0.6%. At the optimal fiber volume fraction, PP fibers with lengths of 3 mm and 9 mm resulted in a 65.25% and 81.62% increase in the four-point bending strength of FABs, respectively. As indicated by DIC measurements, PP fibers with a length of 9 mm were more effective in controlling the horizontal and vertical displacements of FABs under four-point bending loads than that of 3 mm, and the cracks developed more slowly at the same deflection. In addition, PP fibers with a length of 9 mm have stronger crack extension delay characteristics due to longer effective anchorage distance, as evidenced by more frequent acoustic emission ringing counts and higher cumulative ringing counts. The results of the study may provide a theoretical basis for the application of FABs materials in backfilling.