Desulfurization of simulated and commercial liquid fuel on nano-ZnO fabricated walnut shells

The current investigation involved the development of activated carbon, juglans regia activated carbon (JRACs), from walnut shells, scientifically known as Juglans regia. The ZnO nanorods were loaded on the activated carbon and referred to as ZnO@JRACs. Desulfurization efficiency was assessed through batch adsorption and compared to commercial activated carbon known as DARCO. The materials were characterized using PXRD (powder X-ray diffraction), FTIR (Fourier-transform infrared spectroscopy), ICP-AES (inductively coupled plasma atomic emission spectroscopy), BET (Brunauer-Emmett-Teller) surface area analysis, TEM (transmission electron microscopy) imaging, and TGA (thermal gravimetric analysis). The findings indicated that the materials have oxygen functionalities, a porous morphology, and a substantial specific surface area (BET) of 1269.92 m²/g for ZnO@JRACs. Zn atom concentration in the ZnO@JRACs surface was determined to be 1.16 atomic percent using ICP-AES. Desulfurization experiments were conducted on three liquid fuels, namely a single component model fuel, MSF (multicomponent simulated fuel), and commercial fuel (kerosene), under optimized conditions (8 g/L adsorbent dosage in 10 mL of fuel, 15 min of contact time at room temperature). The conditions effectively removed ~ 98.9% of dibenzothiophene (DBT) from the single component model fuel. The observed order for adsorption capacity is as follows: ZnO@JRACs (63.6 mg g^-1) > JRACs (46.3 mg g^-1) > DARCO (26.1 mg g^-1). The analysis of multicomponent simulated fuel (MSF) using gas chromatography-flame photometric detector (GC-FPD) revealed significant removal percentages for different types of thiophenic sulfur. Specifically, the removal percentages were ~ 46.2%, 97.6%, and 99.4% for benzothiophene, dibenzothiophene, and 4, 6-dimethyldibenzothiophene, respectively. Kinetic studies have shown that the adsorption process is governed by a pseudo second-order reaction. Additional thermodynamic studies were conducted to further investigate the mechanism of adsorption. The spent synthesized composite ZnO@JRACs were thermally regenerated and can be reused for up to four cycles.