Denture microbiome shift and changes of salivary inflammatory markers following insertion of 3D printed removable...

The aim of this study was to investigate the microbiome shift of denture biofilm formation, the incidence of Candida and changes of salivary inflammatory markers following insertion of 3-dimensional printed PMMA denture.

This was a pilot study of 6 patients provided with 3D printed (test group) or conventionally heat-cured (control group) removable partial acrylic dentures followed up for 6 weeks. 3 denture swabs were collected at week 1, 3 and 6; and saliva samples were collected at baseline, week 1, 3 and 6 following denture insertion. Microbial DNA was isolated, and the 16S rRNA gene was amplified and sequenced to assess the denture microbiota. The presence of Candida was determined using PCR assay. The levels of salivary biomarkers lactoferrin (LTF) and histatin (HTN) were determined using ELISA.

Denture microbiome of both groups exhibited similar microbial compositions at weeks 1, 3 and 6. However, the percentage of Streptococcus in the test group was significantly lower at week 1 (p < 0.05). Greater bacterial diversity was detected in the test group (p < 0.05; pairwise Wilcoxon) after 6 weeks. The presence of Candida was only detected in one sample of the 3D printed denture (test group) after 6 weeks. The level of LTF biomarkers increased in both groups after 6 weeks, however, the level of HTN increased only in the control group.

Denture microbiome of both groups demonstrated similar microbial compositions. After 6 weeks, 3D printed denture demonstrated higher diversity with delayed microbiome shift compared to conventional heat cure dentures. 3D printed denture may be a viable alternative to conventional denture and it has a potential to delay microbial dysbiosis.

Among wearers, 3D printed denture can potentially reduce the risk of denture stomatitis. A greater diversity may delay or slow the transition of denture microbiome to dysbiosis.