Demonstration of potential DNA contamination introduced by laboratory consumables using Fluorescein

The development of increasingly efficient DNA extraction and profiling kits has increased the amount of allelic information obtained from trace DNA samples, but also inadvertently, increased the detection of DNA contamination. This study aimed to evaluate the potential of DNA transfer using fluorescein, fluorescent under an alternate light source, in the use of a range of forensically relevant DNA profiling consumables. An evaluation of two pre-lysis methods adopting three different sample tubes, some with deliberate seal damage, showed the PrepFiler™ Automated Forensic DNA Extraction Kit caused leakage and crusting when the rim of the PrepFiler™ LySep column was compromised, but no leakage was observed under the same conditions using the Investigator STAR Lyse&Prep kit. The AutoLys tube showed minimal leakage using the PrepFiler™ chemistry. A DNA extract tube with an external thread, similar to the AutoLys tube, showed no leakage after fridge or freezer storage. However, it highlighted that a centrifugal spin does not guarantee all the DNA will pool at the base of the tube. A comparison of adhesive plate sealing films to 8-well strip caps for sealing 96-well PCR plates showed the adhesive plate sealing films presented a lower risk of DNA transfer, largely due to the adhesion of dispersed liquid on the sticky surface of the film. Overall, this study highlighted a number of variables that may be considered in the development of more refined contamination minimisation protocols in respect to increased sensitivities of DNA profiling.