Experimental Evaluation of Geometric and Environmental Effects on Mechanically Fastened Non-Crimp Fabric Composites

Corresponding to marine environmental regulations is important in shipbuilding and marine industries. The application of lightweight composite materials on ships is an effective approach to reducing the emission of greenhouse gases. The mechanical fastening method is a good candidate to assemble composites and conventional metals. The joint geometric and environmental effects are two important factors in mechanically fastened ship and marine structures. In this study, we evaluated the W/D (hole diameter to width ratio) and environmental effects on the bearing strength and failure mode of a mechanically fastened non-crimp fabric (NCF) composite material. To consider the effect of joint geometry, wherein hole diameters of 5, 6, 8, and 10 mm were machined. Further, by selecting three environmental conditions (UV, saltwater and low temperature), we evaluated environmental effects on bearing strength and failure modes of NCF composite specimens. The bearing strength increased as W/D decreased, and the bearing strength of the specimen exposed to low temperature and UV environments increased, while that of the specimen exposed to saltwater remained the same. From the failure mode analysis, the specimen that was exposed to salt fog showed the same failure mode as the unaged specimen. It was observed that the changes in the transition section and new failure mode in the xenon arc and low-temperature specimens.