Study of Flow and Zinc Dross Removal in Hot-Dip Galvanizing with Combined Traveling Magnetic Field

The removal of zinc dross, which continuously generates and partially floats on a molten zinc surface, has been a persistent challenge during hot-dip galvanizing. Herein, a three-dimensional mathematical model coupled with the electromagnetic field, flow field and air-knife jet flow was established to investigate the flow and zinc dross removal in a zinc pot. Two types of traveling magnetic field combined modes (Mode 1 and Mode 2) were compared. The surface dross removal efficiency was introduced to evaluate the ability of the zinc flow field to compel the movement of zinc dross. The research findings indicate that, in comparison to the influence of strip steel line speed, both the electromagnetic field and air-knife jet have a more pronounced effect on altering the flow characteristics of a molten zinc at surface. The dross removal efficiency for Mode 1 is much far superior to that of Mode 2. With an increase in the driving current, the dross removal efficiency increases while the excessive driving current cannot promote the dross removal efficiency significantly.