Related Experiment Video
Updated: Jun 9, 2025

Experimental Investigation of the Hierarchical Control in DC Microgrids Using a Real-time Simulator
Published on: February 14, 2025
Simulation of 1 MWe hybrid solar power plant by the use of nano-fluid with eccentric backup system
Abdul Qadeer1, Mohd Parvez1, Osama Khan2
1Department of Mechanical Engineering, Al-Falah University, Faridabad, 121004, Haryana, India.
Abstract:
In past years, concentrated solar power (CSP) with an energy backup system has been a unique renewable energy utilization system among intermittent renewable energy systems. It could allow a CSP plant to operate as a base load system in the future. This paper simulates a solar power plant for 1 MWe. Parabolic trough collector (PTC) array and linear Fresnel reflector (LFR) field attached consecutively to produce superheated steam at 40 MPa. The Rankine cycle has been used to run the steam turbine and an electricity generator is attached to a steam turbine to convert mechanical energy into electrical energy. Maximum temperature attained at the turbine inlet is 418.13 ˚C in 12:00-13:00 time slot in the month of January. Results show that solar power plant is feasible to produce 1 MWe. The minimum value of the power produced by the generator is 1.01 MWe in November in the 10:00-11:00 time slot whereas the maximum value of generated power is 1.57 MWe in December in the 11:00-12:00 time slot. The overall efficiency of power generated by the Rankine cycle is 21.25% in January in the 10:00-11:00 time slot. An energy storage system is attached to the system to work at night hours or in cloudy weather conditions.
More Related Videos
09:04A Modeling and Simulation Method for Preliminary Design of an Electro-Variable Displacement Pump
Published on: June 1, 2022
06:45Design and Application of a Fault Detection Method Based on Adaptive Filters and Rotational Speed Estimation for an Electro-Hydrostatic Actuator
Published on: October 28, 2022
Related Concept Videos
Fast Decoupled and DC Powerflow
Energy Line and Hydraulic Gradient Line
Faraday Disk Dynamo
Wind Turbine Machine Models
Induction machines interact through the rotating magnetic field generated by the stator and the rotor. The key parameter is slip, which is the difference between synchronous speed and rotor speed relative to synchronous speed. Slip is...
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
Simplified Synchronous Machine Model
In this model, each generator is connected to a...