Influence of the Traverse Speed of the Stylus Tip on Changes in the Areal Texture Parameters of Machined Surfaces

Measurements of areal (3D) surface texture using optical methods are very popular because of the short measurement time compared to the stylus tip technique. However, they are very sensitive to measurement errors. In some cases, optical measurements are not recommended. The stylus measurement method is well known and can be the reference technique for surface texture measurement. The main disadvantage is the long measuring time. This time can be shortened using higher speeds of measurement. The effect of the speed of the measurement of stylus profilometer on changes in surface texture parameters was studied. Fifty surface topographies were measured using the stylus profilometer at speeds 0.5, 1, 2, 3, 4, and 5 mm/s in the same places. Surfaces after lapping, polishing, grinding, milling, laser texturing, and two-process random surfaces were measured and analyzed. Changes in parameters caused by the increase in the traverse speed depend on the characteristics and parameters of the surfaces. The random surfaces changed more than the deterministic ones. The increase in the traverse speed from 0.5 to 1 mm/s caused small changes in the parameters.