Laser-induced nucleation of urea through the control of Insoluble Impurity

Shuai Li1, Xiongfei Xie1, Qingqing Qiu1

  • 1Faculty of Materials Metallurgy and Chemistry, Jiangxi University of Science and Technology, Ganzhou, 341000, People's Republic of China.

Scientific Reports
|October 29, 2024
PubMed

Related Concept Videos

Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
428
Recrystallization: Solid–Solution Equilibria01:10

Recrystallization: Solid–Solution Equilibria

Recrystallization is a purification technique used to separate impurities from solid compounds. In this technique, no chemical reactions occur. Instead, it exploits physical properties only, specifically, the solubility differences between the desired compound and impurities, either at a single temperature or at different temperatures, and under other selected conditions. The solid-solution equilibrium (solubility equilibrium) of each component in the solution represents a binary phase...
1.0K
Washing, Drying, and Ignition of Precipitates00:52

Washing, Drying, and Ignition of Precipitates

After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
883
Colloidal precipitates01:09

Colloidal precipitates

The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
518
Aldehydes and Ketones with Amines: Imine Formation Mechanism01:23

Aldehydes and Ketones with Amines: Imine Formation Mechanism

Imine formation involves the addition of carbonyl compounds to a primary amine. It begins with the generation of carbinolamine through a series of steps involving an initial nucleophilic attack and then several proton transfer reactions. The second part includes the elimination of water, as a leaving group, to give the imine.
Imines are formed under mildly acidic conditions. A pH of 4.5 is ideal for the reaction.
If the pH is low or the solution is too acidic, the reaction slows down in the...
5.3K
Preparation of Amines: Alkylation of Ammonia and Amines01:30

Preparation of Amines: Alkylation of Ammonia and Amines

Alkylation is one of the methods used to prepare amines. Direct alkylation of ammonia or a primary amine with an alkyl halide gives polyalkylated amines along with a quaternary ammonium salt through successive SN2 reactions. This process of making the quaternary salt through the direct alkylation method is called exhaustive alkylation.
Each alkylation step makes the nitrogen center more nucleophilic, which triggers successive alkylations until a quaternary ammonium salt is formed. Considering...
3.3K