Development and characterization of PLA nanocomposites reinforced with bio-ceramic particles for orthognathic...

The clinical application of osteofixation materials is crucial for maxillofacial reconstruction and orthognathic surgeries. To overcome the limitations of traditional metallic implants, bioabsorbable materials are gaining popularity due to their ability to avoid secondary removal surgeries and reduce stress shielding. This study investigates third-generation biomaterials, focusing on polylactic acid (PLA) for its biocompatibility and biodegradability, and hydroxyapatite (HAP) for its bioactive osteoconductive and bioresorbable properties. Eggshell nanoparticles (ES-NP), HAP, and bioinert alumina particles coated with titanium dioxide (TiO₂@Al₂O₃) were prepared using ball milling, co-precipitation, and sol-gel methods, respectively. PLA-based nanocomposites PLA/ESNP/Al₂O₃ (PEA), PLA/HAP/Al₂O₃ (PHA), PLA/ESNP/TiO₂@Al₂O₃ (PEAT), and PLA/HAP/TiO₂@Al₂O₃ (PHAT) were fabricated via solvent casting. Characterization techniques including X-ray Diffraction (XRD), Fourier Transform Infrared Spectroscopy (FT-IR), and Field-Emission Scanning Electron Microscopy (FE-SEM) were used to analyze the developed nanoparticles and composites. Results indicated PEAT and PHAT composites exhibited tensile strengths of 33.59 ± 0.38 MPa and 32.46 ± 0.46 MPa, tensile moduli of 1756.17 ± 95.43 MPa and 2367.21 ± 158.84 MPa, and shore d hardness values of 84.10 ± 1.45 SHN and 78.00 ± 2.25 SHN, respectively. Both composites achieved a wettability angle of ∼65° and surface roughness below 2.19 μm, enhancing osteoblast adhesion. Additionally, MG63 cell viability was approximately 80 %, and hemolysis rates were below 2.17 %, demonstrating their potential for maxillofacial implant applications.