Direct colour printing on zirconia using 222 nm UV-C photons
Xuedong Bai1, Mengxiao Xu1, Shixin Jin1
1Dental Materials Science, Applied Oral Sciences and Community Dental Care, Faculty of Dentistry, The University of Hong Kong, Hong Kong.
Objectives:
To proof the feasibility of direct colour printing on 3Y-TZP using 222 nm UV-C through investigating the degree and durability of the colour changes, and testifying whether surface, mechanical and biological properties are influenced by the treatment.
Methods:
222 nm UV-C light (Irradiance: 1.870 mW/cm2) was used to treat 3Y-TZP for durations from 15 min to 24 h. ΔE*, TP, crystalline structure, surface morphology, Sa, BFS and biological activities were investigated before and after irradiation. SPSS 28.0 was used for statistical analysis (α = 0.05).
Results:
222 nm UV-C irradiation was capable to shade white 3Y-TZP into tooth colours. With the increase of ΔE*, TP decreased, such that the longer the irradiation time, the higher the ΔE* (logarithmic relationship) and lower the TP. Despite the induced optical changes being prone to fade, the process can be predicted by inversely proportional relationships between ΔE*, TP and the testing points. The treated surface exhibited enhanced hydrophilicity, while the recovery phenomenon was observed. Other properties were not altered by the treatment.
Significance:
This is the seminal study demonstrating the feasibility of direct colour printing on 3Y-TZP using 222 nm UV-C. The new relationship between the colour centre and Eg of 3Y-TZP was established, whereas the induced optical changes were stabilised after a certain period and were highly predictable by controlling the irradiation periods. The irradiation was only correlated to the electron excitation and oxygen vacancies, and would not lead to any changes of other properties. A simple, safe and promising approach to achieve satisfactory colours on 3Y-TZP in clinical practice can be developed.
