Minimalist Approach for HoLEP with A Low-Power Holmium Source: A Retrospective Study

Ramazan Inan1, Ibrahim Buldu2

  • 1Department of Urology, Medova Hospital, Konya, Turkey. ramazaninan86@gmail.com.

Urology Journal
|November 5, 2024
PubMed
Abstract

Related Concept Videos

Nuclear Overhauser Enhancement (NOE)01:06

Nuclear Overhauser Enhancement (NOE)

Irradiation of a spin-active nucleus causes an increase or decrease in the signal intensity of neighboring nuclei that are not necessarily chemically bonded or involved in J-coupling. This phenomenon, called the nuclear Overhauser enhancement (NOE), results from through-space interactions between the nuclear spins. The NOE effect decreases with increasing internuclear distance and is generally not observed beyond 4 angstroms. In NOE, dipole-dipole interactions between neighboring spin-active...
Source Transformation01:15

Source Transformation

Source transformation is a fundamental technique employed in circuit analysis, offering a valuable tool for simplifying complex electrical circuits. This technique involves the replacement of either a voltage source in series with a resistor by a current source in parallel with a resistor, or vice versa. The key concept here is that when the original sources are deactivated (turned off), the equivalent resistance at the circuit's end terminals remains the same.
It is essential to note that when...
Superposition Theorem01:18

Superposition Theorem

The superposition principle is a fundamental concept stating that in a linear circuit, the voltage across (or current through) an element can be determined by summing the individual contributions of each independent source acting in isolation. When dealing with linear circuits containing multiple independent sources, this principle serves as a valuable tool for analysis. To apply the superposition principle effectively, one should focus on a single independent source at a time while...
RL Circuit without Source01:14

RL Circuit without Source

When a DC source is suddenly disconnected from an RL (Resistor-Inductor) circuit, the circuit becomes source-free. Assuming the inductor has an initial current denoted as I0, the initial energy stored in the inductor can be determined.
Applying Kirchhoff's voltage law around the loop of the circuit and substituting the voltages across the inductor and resistor yields a first-order differential equation. A logarithmic equation is obtained by rearranging the terms in this equation, integrating...
The Power Superposition Principle01:19

The Power Superposition Principle

Consider a circuit with two sinusoidal voltage sources. Each one influences the circuit independently, and the superposition principle helps us understand the combined effect by adding up the responses from each source.
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...