FRESH 3D printing of zoledronic acid-loaded chitosan/alginate/hydroxyapatite composite thermosensitive hydrogel for...

The aim of this study was to develop a composite thermosensitive hydrogel for bone regeneration applications. This hydrogel consisted of chitosan, alginate and hydroxyapatite, and was loaded with zoledronic acid as a model drug. The feasibility of three-dimensional (3D) printing of the thermosensitive hydrogel using the extrusion based technique was investigated. The 3D printing technique called Freeform Reversible Embedded Suspended Hydrogel (FRESH) printing was employed for this purpose. To characterize the composite hydrogels, several tests were conducted. The gelation time, rheological properties, and in vitro drug release were analyzed. Additionally, the cell viability test on human osteosarcoma MG-63 cells for the composite hydrogel was assessed using an MTT assay. The results of the study showed that the zoledronic acid-loaded composite thermosensitive hydrogel was successfully printed using the FRESH 3D printing technique which was not possible otherwise i.e., by using traditional 3D printing techniques. Further examination of the printed constructs using a Scanning Electron Microscope revealed the presence of porous and layered structures. The gelation times of the composite thermosensitive hydrogel was determined to be 10 and 20 min, respectively for scaffolds with and without HA, indicating the successful formation of the gel within a reasonable time to the FRESH technique. The flow behavior of the hydrogel was found to be pseudoplastic, following a non-Newtonian flow pattern with Farrow's constant (N) values of 1.708 and 1.853 for scaffolds with and without hydroxyapatite, respectively. In terms of drug release, scaffolds prepared with and without hydroxyapatite reached nearly 100% of zoledronic acid release in 360 h and 48 h, respectively. The cell viability test on human osteosarcoma MG-63 cells using MTT assay has shown increased cell viability % in the case of composite hydrogel, indicating biocompatibility of the scaffold. Overall, this study successfully developed a composite thermosensitive hydrogel loaded with zoledronic acid for bone regeneration applications and was 3D printed using the FRESH 3D printing technique. The results of this study provide valuable insights into the potential use of this composite hydrogel for future biomedical applications.