Related Experiment Video
Updated: Jun 7, 2025

Cell-based Assay Protocol for the Prognostic Prediction of Idiopathic Scoliosis Using Cellular Dielectric Spectroscopy
Published on: October 16, 2013
Effect of different corrective force directions applied by spinal orthoses on the patients with adolescent idiopathic
Hui-Dong Wu1, Chang-Liang Luo1,2, Chen He3
1Department of Prosthetic and Orthotic Engineering, School of Rehabilitation, Kunming Medical University, Kunming, China.
Background:
Spinal orthoses are commonly prescribed for adolescent idiopathic scoliosis (AIS), yet their three-dimensional correction was not fully understood. The amount of deformity control largely depends on the corrective forces applied, which remain empirically based due to a lack of consensus on optimal force application. This study investigated the effects of different corrective force directions exerted by spinal orthoses on patients with AIS.
Methods:
A retrospective analysis was conducted on 78 subjects. The trunk was segmented into four quadrants using coronal and sagittal planes from a top-down perspective. Each left or right posterolateral quadrant (with 90°) was further subdivided into zones 1-4, from the sagittal to coronal planes. Based on the zone where the resultant corrective force direction fell, the subjects were categorized into Group 1 (zone 1), Group 2 (zone 2), Group 3 (zone 3), or Group 4 (zone 4). The direction of the corrective force was estimated using modified models of the subjects' bodies, designed through a computer-aided design and manufacturing system integral to the orthosis fabrication process. The effects of corrective forces in different zones on scoliotic spine were assessed.
Results:
Among the subjects, 3 were in Group 1, 17 in Group 2, 52 in Group 3, and 6 in Group 4. Due to the limited number of subjects, data from Groups 1 and 4 were not analysed. Groups 2 and 3 showed significant reductions in Cobb angle in the coronal plane and plane of maximum curvature (PMC) following orthosis fitting (p < 0.05). Group 2 displayed a significant decrease > 5º in thoracic kyphosis (p < 0.05). Both Groups 2 and 3 exhibited significant reductions in lumbar lordosis. PMC orientation remained unchanged over time (p > 0.05) but was notably higher in Group 2 after orthosis fitting (p < 0.05).
Conclusions:
Corrective forces applied by spinal orthoses in zones 2 and 3 effectively controlled lateral curve progression. Notably, only forces in zone 3 neither significantly reduced thoracic kyphosis nor exacerbated the deviation of scoliotic spine from the sagittal plane. Further research is needed to validate and expand upon these results.
More Related Videos
06:28Biomechanical Changes Related to Low Back Pain: An Innovative Tool for Movement Pattern Assessment and Treatment Evaluation in Rehabilitation
Published on: December 13, 2024
04:19Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
Related Concept Videos
General Case of Eccentric Axial Loading
Consider a member subjected to equal and opposite forces that are applied along a line that does not coincide with the member's neutral axis. In unsymmetrical...
Eccentric Axial Loading in a Plane of Symmetry
Normal Strain under Axial Loading