Related Experiment Video
Updated: Jul 8, 2026

Preparation and Use of Photocatalytically Active Segmented Ag|ZnO and Coaxial TiO2-Ag Nanowires Made by Templated Electrodeposition
Published on: May 2, 2014
Eco-Friendly Synthesis of ZnO for Efficient Photodegradation of Pharmaceutical Drug Removal by Photocatalysis
Sharda Pandey1, Anchal Srivastava1, Poonam Rawat2
1Department of Physics, University of Lucknow, Lucknow, U.P. 226007, India.
Abstract:
In the present work, a comparative study on eco-friendly synthesis of zinc oxide (ZnO) sample 1 and sample 2 with 3.17 and 4.17 M NaOH, respectively, is reported. Sample 2 with 4.17 M NaOH is applied in the photocatalytic degradation of paracetamol (pure and raw both) using the ultraviolet (UV, 280-400 nm) and UV/H2O2 reaction systems. Pure paracetamol (PCM1) and raw paracetamol (PCM2) from tablets are used for photocatalytic degradation by photocatalysis. Our experimental evidence show that ZnO sample 2 was more active in the UV/H2O2 reaction system than under ultraviolet (UV, 280-400 nm) irradiation only in the photocatalytic degradation process. Field emission scanning electron microscopy (FE-SEM) confirms the homogeneous growth of a rod-like structure for sample 1 and brittle and randomly aggregated rod-like and wire-like nanostructures for sample 2. The peaks observed in the region around 440 to 900 cm-1 in the FTIR spectra for sample 1 and sample 2 annealed at 250 °C confirms the presence of ZnO bonds. UV absorption spectroscopy indicates a red shift in the absorption spectra due to the increase in the molar concentration of NaOH to 4.17 M for sample 2. In this study, the band gap values are found to be 3.33 and 3.01 eV for the synthesized ZnO sample 1 and sample 2, respectively, which are 40 and 360 meV less as compared to that of bulk ZnO (3.37 eV). The oxidation rate is increased in the UV/H2O2 reaction system, producing the highest rate for PCM1 drug removal with rate constant 9.7 × 10-3 min-1 and half-life 71.5 min. The kinetic study results for the removal of PCM1 and PCM2 show good results and follow the pseudo-first-order kinetic model with correlation coefficients 0.69556 and 0.90851, respectively, whereas PCM2 follows the pseudo-second-order kinetic model with correlation coefficient 0.9993. The experimental and calculated values of removal capacity (q e) at equilibrium is found close to those of the pseudo-second order kinetic model for the removal of both the paracetamol forms PCM1 and PCM2 with the catalyst ZnO nanostructure. The photostability of ZnO sample 2 is also tested with a reusability test in photocatalytic degradation of paracetamol at least four times. The absence of a maxima peak at 243 of PCM1 in the UV/H2O2 reaction system indicates nearly 100% successful conversion of 20 ppm PCM1 by using synthesized catalyst ZnO sample 2. The comparative results of both reaction systems, i.e., UV and UV/H2O2, show that the hydroxyl radicals, as the active species, are responsible for major degradation of both paracetamol forms (PCM1 and PCM2).
More Related Videos
08:30A Complete Method for Evaluating the Performance of Photocatalysts for the Degradation of Antibiotics in Environmental Remediation
Published on: October 6, 2022
06:42Author Spotlight: Exploring the Antibacterial Effects of Zinc Oxide Nanoparticles in Overcoming Antibiotic Resistance
Published on: September 27, 2024
Related Concept Videos
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Enhanced Elimination of Poison
Antidotes serve a crucial role in counteracting the effects of poison by inhibiting enzymes responsible for producing harmful drug metabolites. In some cases, these toxic metabolites can be neutralized by endogenous cosubstrates, which are maintained at specific concentrations to prevent interaction with cellular macromolecules and subsequent cell death.
Renal excretion is the...
Phase I Reactions: Reductive Reactions
Microbial Bioremediation of Pesticides