Marginal Discrepancy and Internal Fit of 3D-Printed Versus Milled Laminate Veneers: An In Vitro Study

The clinical success of laminate veneers depends upon their marginal discrepancy (MD) and internal gap (IG). This study aims to compare and evaluate the MD, overall discrepancy (OD), absolute marginal discrepancy (AMD), and IG of 3D-printed (Varseosmile TrinQ and Varseosmile Crown Plus) and computer-aided design and manufacturing (CAD/CAM)-milled (Brilliant Crios) laminate veneers using cone-beam computed tomography (CBCT). Thirty maxillary central incisors were prepared and divided randomly into three groups (n = 10). All teeth were scanned for veneer fabrication: Group PVT teeth with 3D-printed Varseosmile TrinQ, Group PVC teeth with 3D-printed Varseosmile Crown Plus, and Group BCM teeth with Brilliant Crios milled veneers. The specimens with respective veneers were scanned using CBCT, and the sectional images were measured for IG, MD, OD, and AMD. The mean values for MD recorded were 0.27, 0.31, and 0.40 for PVT, PVC, and BCM respectively). The mean values for IG recorded were as follows: PVT group-0.24, PVC group-0.28, and BCM group-0.39, and those for OD were as follows: PVT-0.22, PVC-0.32, and BCM-0.41. Intragroup significance was observed for IG and OD (p = 0.001). Findings revealed that milled veneers have a higher IG and MD than 3D-printed veneers, making them less clinically acceptable.