A new method to assess the performance of anti-scatter grids in x-ray projection imaging

Purpose.This work proposes a new method to assess the performance of radiographic anti-scatter grids (ASGs) without the use of a narrow primary beam, which is difficult to achieve.Method.Three general purpose ASGs were evaluated, two marketed ASGs and a low frequency and high ratio prototype ASG with molybdenum lamellae. A range of high scatter x-ray beams were used in a standardized geometry, with energies ranging from 60 kV to 121 kV, for five beam sizes between 10 × 10 and 30 × 30 cm². The scatter fraction (SF) of each beam was measured in the image plane with and without ASG using the lead beam stop method with an extrapolation function derived from the scatter point spread function (PSF).Results.The primary, scatter and total transmissions of the three ASGs measured for the different x-ray beams allowed the calculation of the grid factor, contrast improvement factor and detective quantum efficiency (DQE) as functions of the input SF. The results obtained for the three ASGs are consistent with those obtained with the standard narrow-beam method and data published in the literature, confirmed the prime importance of the ASG primary transmission and revealed important variations in ASG performance, especially as a function of the input SF and beam size. The break-even input SFs at which the imaging system efficiency was improved by the ASG ranged between 0.18 and 0.52 for the different ASGs and beam characteristics.Significance.The method is proposed as an alternative to current ASG characterization techniques.