Related Experiment Video

Updated: Jun 6, 2025

A Method for Studying the Temperature Dependence of Dynamic Fracture and Fragmentation
09:12

A Method for Studying the Temperature Dependence of Dynamic Fracture and Fragmentation

Published on: June 28, 2015

8.5K

High temperature wear and corrosion behavior of detonation sprayed Fe-based amorphous coatings

Lu Xie1, Yueming Wang2

  • 1School of Management Engineering, Jiangsu Urban and Rural Construction Vocational College, Changzhou, 213147, People's Republic of China.

Scientific Reports
|November 26, 2024
PubMed

Keywords:
Amorphous coatingsDetonation sprayElectrochemical corrosion behaviorHigh temperature wear behavior

More Related Videos

Conducting Elevated Temperature Normal and Combined Pressure-Shear Plate Impact Experiments Via a Breech-end Sabot Heater System10:52

Conducting Elevated Temperature Normal and Combined Pressure-Shear Plate Impact Experiments Via a Breech-end Sabot Heater System

Published on: August 7, 2018

8.5K
Preparation and Reactivity of Gasless Nanostructured Energetic Materials09:50

Preparation and Reactivity of Gasless Nanostructured Energetic Materials

Published on: April 2, 2015

10.2K

Related Concept Videos

Atomic Spectroscopy: Effects of Temperature01:27

Atomic Spectroscopy: Effects of Temperature

Atomization, converting samples into gas-phase atoms and ions, is essential for atomic spectroscopy. The flame temperature required for atomization affects the efficiency of the atomic spectroscopic methods by increasing the atomization efficiency and the relative population of the excited and ground states.
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
304
Atomic Absorption Spectroscopy: Atomization Methods01:25

Atomic Absorption Spectroscopy: Atomization Methods

Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the...
373