Cavitation and Solid-State Post-Condensation of Polyethylene Terephthalate: Literature Review

Polyethylene terephthalate (PET) is widely used in bottle production by stretch blow molding processes (SBM processes) due to its cost-effectiveness and low environmental impact. The presented literature review focuses on microcavitation and solid-state post-condensation effects that occur during the deformation of PET in the SBM process. The literature review describes cavitation and microcavitation effects in PET material and solid-state post-condensation of PET on the basis of a three-phase model of the PET microstructure. A three-phase model of PET microstructure (representing the amorphous phase in two ways, depending on the ratio of the trans-to-gauche conformation of the PET macromolecule and the amount of free volume) with a nucleation process, a crystallization process, and the use of positron annihilation lifetime spectroscopy (PALS) to analyze PET microstructure are discussed in detail. The conceptual model developed based on the literature combines solid-state post-condensation with microcavitation via the diffusion of the post-condensation product. This review identifies the shortcomings of the developed conceptual model and presents them with five hypotheses, which will be the basis for further research.