Related Experiment Video
Updated: Jun 5, 2025

Nanofabrication of Gate-defined GaAs/AlGaAs Lateral Quantum Dots
Published on: November 1, 2013
Observation of nonlinearity-controlled switching of topological edge states
Antonina A Arkhipova1,2, Sergey K Ivanov1, Sergey A Zhuravitskii1,3
1Institute of Spectroscopy, Russian Academy of Sciences, 108840, Troitsk, Moscow, Russia.
Abstract:
We report the experimental observation of the periodic switching of topological edge states between two dimerized fs-laser written waveguide arrays. Switching occurs due to the overlap of the modal fields of the edge states from topological forbidden gap, when they are simultaneously present in two arrays brought into close proximity. We found that the phenomenon occurs for both strongly and weakly localized edge states and that switching rate increases with decreasing spacing between the topological arrays. When topological arrays are brought in contact with nontopological ones, switching in topological gap does not occur, while one observes either the formation of nearly stationary topological interface mode or strongly asymmetric diffraction into the nontopological array depending on the position of the initial excitation. Switching between topological arrays can be controlled and even completely arrested by increasing the peak power of the input signal, as we observed with different array spacings.
More Related Videos
09:49In Situ Transmission Electron Microscopy with Biasing and Fabrication of Asymmetric Crossbars Based on Mixed-Phased a-VOx
Published on: May 13, 2020
11:33All-electronic Nanosecond-resolved Scanning Tunneling Microscopy: Facilitating the Investigation of Single Dopant Charge Dynamics
Published on: January 19, 2018
Related Concept Videos
Switching of BJT
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...
Biasing of FET
In an N-channel JFET, the structure consists of N-type material forming the channel on a P-type substrate, with the...
Biasing of P-N Junction
In equilibrium, no external voltage is applied across the p-n junction. The depletion region is formed at the junction interface due to the diffusion of carriers, which leaves behind charged dopants, acceptors on the p-side, and donors on the n-side. These immobile charges create an electric field that prevents further diffusion of carriers. The related energy band...
MOSFET: Depletion Mode
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity...