Related Experiment Video
Updated: Jun 5, 2025

Demonstration of Spin-Multiplexed and Direction-Multiplexed All-Dielectric Visible Metaholograms
Published on: September 25, 2020
96-Channel on-chip reconfigurable optical add-drop multiplexer for multidimensional multiplexing systems
Weike Zhao1, Yingying Peng1, Xiaoping Cao2,3
1State Key Laboratory for Modern Optical Instrumentation, Center for Optical & Electromagnetic Research, College of Optical Science and Engineering, International Research Center for Advanced Photonics, Zhejiang University, Zijingang Campus, Hangzhou 310058, China.
Abstract:
The multi-dimensional multiplexing technology is very promising for further increasing the link capacity of optical interconnects. A 96-channel silicon-based on-chip reconfigurable optical add-drop multiplexer (ROADM) is proposed and demonstrated for the first time to satisfy the demands in hybrid mode/polarization/wavelengthdivision-multiplexing systems. The present ROADM consists of a six-channel mode/polarization de-multiplexer, a 6 × 16 array of microring-resonator (MRR)-based wavelength-selective switches, and a six-channel mode/polarization multiplexer. With such a ROADM, one can add/drop optical signals to/from any channels of the multimode bus waveguide arbitrarily. For the designed and fabricated ROADM chip, there are more than 1000 elements integrated monolithically, including 96 MRRs, 576 waveguide crossings, 192 grating couplers, 96 micro-heaters, 112 pads, six polarization-splitter-rotators (PSRs), four asymmetric adiabatic couplers and four asymmetric directional couplers. For any channel added/dropped with the fabricated ROADM, the on-chip excess loss is about 5-20 dB, the inter-mode crosstalk is <-12 dB, and the inter-wavelength crosstalk is <-24 dB. The system experiments are demonstrated by using 10-GBaud quadrature phase shift keying (QPSK) signals, showing that the observed optical signal noise ratio (OSNR) power penalties induced by the ROADM are less than 2 dB at a BER of 3.8 × 10-3.
Related Concept Videos
Design Example: Capacitance Multiplier Circuit
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Bus Impedance Matrix
In the first circuit, all machine voltage sources are short-circuited, leaving only the prefault voltage source at the fault location. The positive-sequence bus impedance matrix can be determined by solving the nodal equations,...

